MATT
what's it for
- For floor maintenance and matt finish for treatments of terracotta, quarry tiles, tumbled marble and natural stone floors.
- The ideal finishing coat after the application of a water-based water-proofing sealer.
- Ideal on interior walls made of bricks and natural stones, on decorative coverings made of gypsum, manufactured stone and concrete to prevent flaking and strengthen the surface.
advantages
- Provides natural finish.
- Highly concentrated: can be diluted according to requirements.
- Can be polished to achieve a satin effect.
- Completely removable.
- Has a high self-levelling capacity.
- Dirt and dust repellent.
ideal for
- TERRACOTTA
- QUARRY TILES
- UNPOLISHED STONE AND AGGLOMERATES
- TUFF
- RESIN
- CEMENT TILES
- PVC
- LVT
- SPC
- RUBBER
Method of use
Dilution: either undiluted or diluted according to requirements. For the protection of floors and bare walls:
Dilute MATT slightly to make it more fluid and easier to apply, by adding 200 ml of water per litre of product. On a clean and dry surface, apply one even coat of MATT using fleece (wall brush).
Wait until completely dry (about an hour) and then apply a second coat in the opposite direction to the first (i.e. horizontal if previously applied vertically or vice-versa). The floor can be walked on after one hour. For a greater sheen, buff with a floor polishing machine or a wool cloth. If treating terracotta and highly absorbent natural stone (limestone, sandstone, old quarries, rough quartzite), we recommend a base coat of a water-proofing product such as FOB XTREME or W68.Renewal of the finish (every 2-3 months): after cleaning the surface with a diluted solution of CLEANER PRO (1:200), apply MATT by diluting 500 ml of product in 5 litres of water. The floor can be walked on once dry. Restoration of the protection: remove the wax from the surface using the PS87 PRO detergent, diluted 1:5. Rinse the surface.Once the floor is dry, apply the wax slightly diluted (200 ml of water per litre of product) using a fleece pad, cloth or other applicator. The floor can be walked on once dry.For Anti-flaking treatment: apply an even coat of undiluted MATT to the dry floor using a brush. The treated surface will be dry after approximately one hour.CLEANING OF TOOLS: clean with water after use.For ordinary maintenance: use a diluted solution of CLEANER PRO (1:200)
Do not walk on floor while it’s drying and do not repeat application on treated areas which are not yet dry. To remove this wax, use the specific wax-remover PS87 PRO. Do not use the product on external surfaces, in damp environments and where water puddles may form (bathrooms, showers). The product can change the appearance of the material, first spot test a small surface area to check for any changes.
coverage
- Terracotta30 m²
- Stone30-40 m²
- Coverage shown is indicative and refers to single coats